Active Fibrillin 1 (FBN1) Mus musculus (Mouse) Active protein

FBN; MASS; MFS1; OCTD; SGS

Add to Cart Distributors
Overview
Properties
  • Buffer Formulation20mM Tris, 150mM NaCl, pH8.0, containing 1mM EDTA, 1mM DTT, 0.01% SKL, 5% Trehalose and Proclin300.
  • Traits Freeze-dried powder, Purity > 97%
  • Isoelectric Point5.6
Share your citation Upload your experimental result Review Leave a message
Loading...

Share a new citation as an author

Upload your experimental result

Review

Please attach serial No. on instruction manual

Contact us

Please fill in the blank.

Name*
Organization
Address
E-mail address*
Telephone
Inquiry*
Verification code* CheckCode
  • Active Fibrillin 1 (FBN1) Packages (Simulation)
  • Active Fibrillin 1 (FBN1) Packages (Simulation)
  • APA593Mu01.png Figure. SDS-PAGE
  • Active Fibrillin 1 (FBN1) Figure. Western Blot
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Activity test

Figure. The binding activity of FBN1 with FBLN2.
Fibrillin 1 (FBN1) is a 230-kb gene with 65 coding exons that encode a 2,871-amino-acid long proprotein called profibrillin which is proteolytically cleaved near its C-terminus by the enzyme furin convertase to give fibrillin-1, a member of the fibrillin family, and the 140-amino-acid long protein hormone asprosin. FBN1 is a large, extracellular matrix glycoprotein that serves as a structural component of 10-12nm calcium-binding microfibrils. These microfibrils provide force bearing structural support in elastic and nonelastic connective tissue throughout the body. Besides, Fibulin 2 (FBLN2) has been identified as an interactor of FBN1, thus a binding ELISA assay was conducted to detect the interaction of recombinant mouse FBN1 and recombinant mouse FBLN2. Briefly, FBN1 were diluted serially in PBS, with 0.01% BSA (pH 7.4). Duplicate samples of 100μL were then transferred to FBLN2-coated microtiter wells and incubated for 2h at 37℃. Wells were washed with PBST and incubated for 1h with anti-FBN1 pAb, then aspirated and washed 3 times. After incubation with HRP labelled secondary antibody, wells were aspirated and washed 3 times. With the addition of substrate solution, wells were incubated 15-25 minutes at 37℃. Finally, add 50µL stop solution to the wells and read at 450nm immediately. The binding activity of FBN1 and FBLN2 was shown in Figure 1, and this effect was in a dose dependent manner.

Usage

Reconstitute in 20mM Tris, 150mM NaCl (pH8.0) to a concentration of 0.1-1.0 mg/mL. Do not vortex.

Storage

Avoid repeated freeze/thaw cycles. Store at 2-8°C for one month. Aliquot and store at -80°C for 12 months.

Stability

The thermal stability is described by the loss rate. The loss rate was determined by accelerated thermal degradation test, that is, incubate the protein at 37°C for 48h, and no obvious degradation and precipitation were observed. The loss rate is less than 5% within the expiration date under appropriate storage condition.

Recommend products