Active Ribonuclease P (RNASEP) Rattus norvegicus (Rat) Active protein

Rnase-P; RNASEP1; RPP40; Ribonuclease P/MRP 40kDa Subunit

Add to Cart Distributors
Overview
Properties
  • Buffer FormulationPBS, pH7.4, containing 0.01% SKL, 5% Trehalose.
  • Traits Freeze-dried powder, Purity > 97%
  • Isoelectric Point6.2
Share your citation Upload your experimental result Review Leave a message
Loading...

Share a new citation as an author

Upload your experimental result

Review

Please attach serial No. on instruction manual

Contact us

Please fill in the blank.

Name*
Organization
Address
E-mail address*
Telephone
Inquiry*
Verification code* CheckCode
  • Active Ribonuclease P (RNASEP) Packages (Simulation)
  • Active Ribonuclease P (RNASEP) Packages (Simulation)
  • APA198Ra01.jpg SDS-PAGE
  • Active Ribonuclease P (RNASEP) Figure. Western Blot; Sample: Recombinant RNASEP, Rat.
  • Certificate ISO9001: 2008, ISO13485: 2003 Registered

Activity test

Ribonuclease P is a site specific endonuclease that generates mature tRNAs by catalysing the removal of the 5'-leader sequence from pre-tRNA to produce the mature 5'-terminus. It can also cleave other RNA substrates such as 4.5S RNA. In bacteria, RNase P consists of of two components: a large RNA (about 400 base pairs) encoded by rnpB, and a small protein (119 to 133 amino acids) encoded by rnpA. The RNA moiety of RNase P carries the catalytic activity; the protein component plays an auxiliary, but essential, role in vivo by binding to the 5'-leader sequence and broadening the substrate specificity of the ribozyme. The sequence of rnpA is not highly conserved, however there is, in the central part of the protein, a conserved basic region. Besides, Nucleophosmin (NPM) has been identified as an interactor of RNASEP, thus a binding ELISA assay was conducted to detect the interaction of recombinant rat RNASEP and recombinant rat NPM. Briefly, RNASEP were diluted serially in PBS, with 0.01% BSA (pH 7.4). Duplicate samples of 100uL were then transferred to NPM-coated microtiter wells and incubated for 2h at 37℃. Wells were washed with PBST and incubated for 1h with anti-RNASEP pAb, then aspirated and washed 3 times. After incubation with HRP labelled secondary antibody, wells were aspirated and washed 3 times. With the addition of substrate solution, wells were incubated 15-25 minutes at 37℃. Finally, add 50µL stop solution to the wells and read at 450nm immediately. The binding activity of of RNASEP and NPM was shown in Figure 1, and this effect was in a dose dependent manner.

Usage

Reconstitute in 10mM PBS (pH7.4) to a concentration of 0.1-1.0 mg/mL. Do not vortex.

Storage

Avoid repeated freeze/thaw cycles. Store at 2-8°C for one month. Aliquot and store at -80°C for 12 months.

Stability

The thermal stability is described by the loss rate. The loss rate was determined by accelerated thermal degradation test, that is, incubate the protein at 37°C for 48h, and no obvious degradation and precipitation were observed. The loss rate is less than 5% within the expiration date under appropriate storage condition.

Recommend products